Adams Rite PS-EXIT Power Supply for 8000 and 3000 Series w/ LR/MLR Device, 115/230 VAC Input, 1.6 AMP Output

Adams Rite PS-EXIT Power Supply For 8000 and 3000 Series with Latch Retraction or Motorized Latch Retraction Device, 115/230 VAC Input, 1.6 AMP Output, Controls Up to 2 Devices

Power supply for all 8000 and 3000 Series Exit Devices with Motorized Latch Retraction (MLR) or Electric Latch Retraction (LR) option.

• PS-EXIT is designed to replace PS-SE and PS-LR models.
• Adams Rite recommends that for optimal performance all exit devices with the MLR or LR options are installed and powered using PS-EXIT power supplies. Failure to do so may cause permanent damage to the exit device.

Function
This power supply is designed to provide power and control for up to two MLR or LR exit devices. Each exit device is controlled by a timer that is initiated by a switch closure. The timer is user-configured and holds the exit device(s) in the unlatched position for 2 – 60 seconds. At the end of the selected time, the exit device(s) will re-latch. If the switch controlling the exit device is closed longer than the selected time, the exit device remains unlatched until the controlling switch is released.

• An optional mode is available that allows both retraction timers to activate in response to a closure of either switch.
• Exit devices under access system control remain latched during a complete power failure but always allow free mechanical egress.

Features

Housing
Hinged, steel cabinet measures 10” x 10-3/8” x 4-1/8” [254 mm x 263.5 mm x 104.8 mm]. Blue, baked enamel finish with knockouts for conduit connections. Sized to accommodate two sealed, lead acid batteries (7AH, not included).

Timer
Initiated by switch closure to control each exit device. Timer is user-configured and holds exit device in unlatched position for 2 - 60 seconds. At end of selected time, exit device will re-latch.

Operating Modes
The PS-EXIT is designed to power up to two 8000/3000 MLR or LR exit devices in the following two modes:
• Single Input (Sequential Operation): either input retracts the corresponding exit device followed by retraction of the second device. Control double door exit with one input.
• Dual Input (Independent Operation): Each exit device is controlled by its own input switch. Control two separate exits with two inputs.

Electrical
Input power: 115 VAC

Rated Output Current: Up to 0.8A per channel continuous rated output current

Typical Output Voltage
• 24 – 26 VDC output voltage
• Up to 17 A pull-in current

Certifications
• UL294
• CAN/CSA-C22.2 No. 223

Shipping Weight
10 lbs [4.5 kg]

Model: Adams Rite PS-EXIT